r
NON-USE
AND VACATION
CARE
Operate your washer only when you are home.
If moving, or not using your washer for a period of time,
follow these steps:
1. Unplug or disconnect
power to washer.
2. Turn off water supply to washer, to avoid flooding
due to water pressure surge.
r
CLEANING
YOUR DISPENSER
You may find laundry product residue leftover in your
dispenser drawer. To remove residue, follow this
recommended
cleaning procedure:
1. Pull drawer out until you feet resistance.
2. Push 1 tab downward,
and then continue pulling out.
3. Wash in warm, soapy water, using a mild detergent.
4. Rinse with warm water.
5. Air dry, or dry with a towel, then place back into slot.
IMPORTANT:
Dispenser drawer and tray are not
dishwasher safe.
WINTER
STORAGE
CARE
iMPORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect
and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and
run washer on RINSE & SPIN cycle for about
30 seconds to mix antifreeze and remaining water.
3. Unplug washer or disconnect
power.
f
TRANSPORTING
YOUR WASHER
1.
2.
3.
4.
5.
6.
7.
Shut off both water faucets. Disconnect
and drain water
inlet hoses.
If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
Disconnect
drain from drain system.
Unplug power cord.
Place inlet hoses inside washer basket.
Drape power cord and drain hose over the console
and secure with masking tape.
Place foam packing ring from original shipping materials
back inside washer. If you do not have packing ring,
place heavy blankets or towels into basket opening.
Close lid and place tape over lid and down front of
washer. Keep lid taped until washer is placed in
new location. Transport Washer in the upright possition.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong,
Do not use an adapter.
Do not use an extension cord.
Failure to follow
these instructions can result in death,
fire, or electrical
shock.
r
REINSTALLING/USING
WASHER
AGAIN
To reinstall washer after non-use, vacation, winter storage
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended
procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
2.
3.
Plug in washer or reconnect power.
Run washer through Bulky/Sheets and Deep Water
Wash cycle to clean washer and remove antifreeze,
if used. Use only HE High Efficiency detergent. Use
half the manufacturer's
recommended
amount for a
medium-size
load.
14
ページを印刷する