- ページ 14

ドライヤー Whirlpool Centennial MEDC700のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Centennial MEDC700 16 ページ。 27" wide models - u.s.a. only

ページを印刷する

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer's final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is level. See "Level Dryer."

6. For power supply cord installation, plug into an outlet.

For direct wire installation, turn on power.

7. Remove the protective film on the console and any tape

remaining on the dryer.

8. Wipe the dryer drum interior thoroughly with a damp cloth

to remove any dust.

9. Read "Dryer Use" in the Dryer User Instructions.

10. Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

If the dryer will not start, check the following:

Controls are set in a running or "On" position.

■

Start button has been pushed firmly.

■

Dryer is plugged into an outlet and/or electrical supply

■

is on.

Household fuse is intact and tight, or circuit breaker has

■

not tripped.

Dryer door is closed.

■

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, turn off dryer, and check the

following:

There may be 2 household fuses or circuit breakers for

■

the dryer. Check that both fuses are intact and tight, or

that both circuit breakers have not tripped. If there is still

no heat, contact a qualified technician.

noTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used.

The odor will go away.

Reverse Door Swing (optional)

You can change your door swing from a right-side opening to a

left-side opening, if desired.

1. Place towel (A) on top of dryer to avoid damaging the surface.

2. Open dryer door. Remove bottom screws from cabinet side of

hinges (B). Loosen (do not remove) top screws from cabinet

side of hinges.

3. Lift door until top screws in cabinet are in large part of hinge

slot. Pull door forward off screws. Set door (handle side up)

on top of dryer. Remove top screws from cabinet.

4. Remove screws attaching hinges to door.

5. Remove screws at top, bottom, and side of door (4 screws).

Holding door over towel on dryer, grasp sides of outer door

and gently lift to separate it from inner door. Do not pry apart

with putty knife. Do not pull on door seal or plastic door

catch.