- ページ 18

ドライヤー Whirlpool CGM2745FQ0のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool CGM2745FQ0 29 ページ。 Commercial gas or electric

ELECTRIC DRYER ELECTRICAL CONNECTIONS

Connection Options

Power Cord

4-wire receptacle (NEMA Type 14-30R)

Go to "Power Supply Cord Connection" section.

3-wire receptacle (NEMA Type 10-30R)

Go to "Power Supply Cord Connection" section.

NOTE: If local codes do not permit connection of a cabinet-ground conductor to neutral wire, go to "Connecting 3-Wire

Connection: Optional" section. This connection may be used with either a power supply cord or a direct wire connection.

Power Supply Cord Connection

Remove Terminal Block Cover

Remove hold-down screw and terminal block cover.

(FOR U.S.A. ONLY)

Direct Wire

4-wire direct

Go to "Direct Wire Connection" section.

3-wire direct

Go to "Direct Wire Connection" section.

Power Supply Cord Strain Relief

1. Insert strain relief.

Remove the screws from a ¾" (19 mm) UL listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole below the terminal block opening

(B) so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

2. Insert power cord into strain relief.

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight fit with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.