- ページ 4

ドライヤー Whirlpool YWED9500EのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool YWED9500E 26 ページ。 Gas and electric dryer

ページを印刷する

INSTALLATION REQUIREMENTS

TOOLS AND PARTS

Gather the required tools and parts before starting

installation.Read and follow the instructions provided

with any tools listed here.

Tools needed for all installations:

Flat-blade screwdriver

Level

Plastic putty knife

Tin snips (new vent

installations)

#2 Phillips screwdriver

Tape measure

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

Vent clamps

Caulking gun and

compound (for installing

new exhaust vent)

1/4" ( 6 mm) nut driver

(recommended)

Wire stripper (direct wire

installations)

Pliers

Tools needed for gas installations:

8" (203 mm) or 10"

(254 mm) pipe wrench

Pipe-joint compound

resistant to LP gas

Parts supplied (all models):

Leveling legs (4)

Parts supplied (steam models):

"Y" connector

Short inlet hose

Parts package is located in dryer drum. Check that all parts

are included.

Parts needed (steam models):

5' (1.52 m) inlet hose

If using a power supply cord:

Use a UL listed power supply cord kit marked for use with

clothes dryers. The kit should contain:

A UL listed 30-amp power supply cord, rated 120/240

■

volt minimum, with a temperature rating of 140° F (60° C)

minimum. The cord should be type SRD or SRDT and be

at least 4 ft. (1.22 m) long. The wires that connect to

the dryer must end in ring terminals or spade terminals

with upturned ends.

A UL listed strain relief.

■

8" (203 mm) or 10"

(254 mm) adjustable wrench

(for gas connections)

Rubber washer

(4)