Whirlpool YWED9500E Інструкція з монтажу Посібник з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Сушарка Whirlpool YWED9500E. Whirlpool YWED9500E 26 сторінок. Gas and electric dryer
Друкувати сторінку
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting
installation.Read and follow the instructions provided
with any tools listed here.
Tools needed for all installations:
Flat-blade screwdriver
Level
Plastic putty knife
Tin snips (new vent
installations)
#2 Phillips screwdriver
Tape measure
4
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Vent clamps
Caulking gun and
compound (for installing
new exhaust vent)
1/4" ( 6 mm) nut driver
(recommended)
Wire stripper (direct wire
installations)
Pliers
Tools needed for gas installations:
8" (203 mm) or 10"
(254 mm) pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied (all models):
Leveling legs (4)
Parts supplied (steam models):
"Y" connector
Short inlet hose
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed (steam models):
5' (1.52 m) inlet hose
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240
■
volt minimum, with a temperature rating of 140° F (60° C)
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL listed strain relief.
■
8" (203 mm) or 10"
(254 mm) adjustable wrench
(for gas connections)
Rubber washer
(4)