- ページ 8

換気フード Whirlpool 36'' Freestanding Gas RangeのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 36'' Freestanding Gas Range 28 ページ。 30" and 36" gas sealed burner cooktop
Whirlpool 36'' Freestanding Gas Range にも：取付説明書 (13 ページ), 取付説明書 (10 ページ), 取付説明書 (7 ページ), 取付説明書 (7 ページ), 取扱説明書 (28 ページ), 取付説明書 (6 ページ), 取付説明書 (7 ページ), インストレーション・インストラクション (5 ページ)

Install Range Hood

1. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install 2 - 5 x 45 mm lower mounting screws and tighten.

1. Install transition on top of hood (if removed for shipping) with

2 - 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over the exhaust outlet.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket using

4 - 4.2 x 8 mm screws.

2. Measure from the bottom of the air deflector to the bottom of

the hood outlet.

3. Cut the duct to the measured size (X).

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket with

the 4 assembly screws.

8. Seal connections with vent clamps.

A. Assembly screws

B. Air deflector

C. Duct cover bracket

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet