- ページ 4

換気フード Whirlpool 9763375のPDF 取付説明書および取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 9763375 28 ページ。 30" (76.2 cm) and 36" (91.4 cm) wall-mount canopy range hood

ページを印刷する

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the safety instructions provided with any tools

listed here.

Tools needed:

■

level

■

drill with 1 " (3 cm),

" (9.5 mm),

" (3 mm) drill bits

■

pencil

■

wire stripper or utility knife

■

measuring tape or ruler

■

pliers

■

caulking gun and weatherproof caulking compound

■

duct tape

■

jig saw or keyhole saw

■

flat blade screwdriver

■

metal snips

■

Phillips screwdriver

Parts needed:

■

1 x

" conduit

■

1 wall or roof cap

■

metal vent system

■

2 charcoal filters – for non-vented (recirculating)

installations only

Parts supplied:

Remove parts from packages. Check that all parts were included.

■

hood canopy assembly with ventilator and light bulbs installed

■

deflector for non-vented (recirculating) installations

■

plastic transition with back draft dampers installed

■

Installation Instructions and Use & Care Guide

■

filter(s) – depending on model and size

■

screws and drywall anchors

■

2 mounting hooks

■

vent cover support bracket

■

mounting template

■

2 piece vent cover

■

rubber tape

INSTALLATION REQUIREMENTS

" (2.75 mm) and

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Canopy hood location should be away from strong draft areas,

such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given

dimensions provide minimum clearance.

Grounded electrical outlet is required. See "Electrical

requirements" section.

The canopy hood is factory set for venting through the roof or

wall. For non-vented (recirculating) installations see "Non-vented

(recirculating) installations" in "Prepare Mounting Location"

section.

All openings in ceiling and wall where canopy hood will be

installed must be sealed.

Product Dimensions

(20.3 cm)

6 "

(17.1 cm)

upper vent

cover

lower vent

cover

(51.3 cm)

NOTE: For reduced ceiling height vented and non-vented (recirculating)

installations, only the upper vent cover, which is 26" (66.0 cm), is used.

9 " (24.4 cm) min.

26" (66.0 cm) max.

26" (66.0 cm)

min.

42 " (107.6 cm)

16 "

max.

(42.5 cm)

9 "

(24.1 cm)

30" (76.2 cm) or

36" (91.4 cm)