- ページ 8

換気フード Whirlpool Build-in 30 inchのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool Build-in 30 inch 24 ページ。 30" electric built-in cooktop with glass-ceramic smooth top
Whirlpool Build-in 30 inch にも：取付説明書 (8 ページ)

ページを印刷する

1. Remove terminal box cover.

A. Terminal box cover

2. Depending on your installation remove either back or top

wiring knockout.

A. Wiring hole knockouts

3. Install the 7" (17.8 cm) round damper (supplied) over the

7" (17.8 cm) round discharge collar of the vent hood.

A. 7" (17.8 cm) Round damper (supplied)

B. 7" (17.8 cm) Round discharge collar

4. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

A. Keyhole slot

Install Range Hood

5. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.

6. Install the four #10 x ⁵⁄₈" mounting screws in pilot holes.

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

7. For Direct Wire Installations:

8. Using 2 people, lift range hood into final position, feeding

9. Check that the damper rotates up and down freely.

10. Connect ventwork to hood. Seal joints with clamps to make

A. Drill pilot hole

Leave about ¹⁄₄" (6.4 cm) space between screw heads and

cabinet to slide range hood into place.

WARNING

Electrical Shock Hazard

Install a UL listed or CSA approved strain relief.

A. UL listed or CSA approved strain relief

Pull about 12" (30 cm) of wire through wall or cabinet and

into opening.

For Power Supply Installations:

Follow instructions included with power supply cord kit

marked for range hoods.

electrical wire through wiring opening. Position the range

hood so that the large end of the keyhole slots are over the

screws. Then push the hood toward the wall so that the

screws are in the neck of the slots. Tighten mounting screws

to cabinet, making sure mounting screws are in narrow neck

of slots.

secure and airtight.

¹⁄₄"

(6.4 mm)