Whirlpool Build-in 30 inch Инструкции по установке и руководство по эксплуатации и уходу - Страница 8
Просмотреть онлайн или скачать pdf Инструкции по установке и руководство по эксплуатации и уходу для Вентиляционная вытяжка Whirlpool Build-in 30 inch. Whirlpool Build-in 30 inch 24 страницы. 30" electric built-in cooktop with glass-ceramic smooth top
Также для Whirlpool Build-in 30 inch: Руководство по установке (8 страниц)
Печатать страницу
1. Remove terminal box cover.
A. Terminal box cover
2. Depending on your installation remove either back or top
wiring knockout.
A
A. Wiring hole knockouts
3. Install the 7" (17.8 cm) round damper (supplied) over the
7" (17.8 cm) round discharge collar of the vent hood.
A
B
A. 7" (17.8 cm) Round damper (supplied)
B. 7" (17.8 cm) Round discharge collar
4. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
A. Keyhole slot
8
Install Range Hood
5. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.
A
6. Install the four #10 x ⁵⁄₈" mounting screws in pilot holes.
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
7. For Direct Wire Installations:
8. Using 2 people, lift range hood into final position, feeding
9. Check that the damper rotates up and down freely.
10. Connect ventwork to hood. Seal joints with clamps to make
A. Drill pilot hole
Leave about ¹⁄₄" (6.4 cm) space between screw heads and
cabinet to slide range hood into place.
WARNING
Electrical Shock Hazard
Install a UL listed or CSA approved strain relief.
A. UL listed or CSA approved strain relief
Pull about 12" (30 cm) of wire through wall or cabinet and
into opening.
For Power Supply Installations:
Follow instructions included with power supply cord kit
marked for range hoods.
electrical wire through wiring opening. Position the range
hood so that the large end of the keyhole slots are over the
screws. Then push the hood toward the wall so that the
screws are in the neck of the slots. Tighten mounting screws
to cabinet, making sure mounting screws are in narrow neck
of slots.
secure and airtight.
A
¹⁄₄"
(6.4 mm)
A