- ページ 3

換気フード Whirlpool RH6330XL SERIESのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool RH6330XL SERIES 6 ページ。 Rh6330xl series convertible oven vent hood

ページを印刷する

ELECTRICAL

VENT CUTOUTS

CUTOUT

DUCTLESS

VENT COVER

FIGURE 3

B. Locating vent

cutouts

1. Open flip front of hood and remove aluminum filter.

Note: Remove packing screw on top of hood before

trying to remove filter.

2. Location for vent opening can be found by measur-

ing locations

given in Figure 3 or by removing

appropriate

venting

knockout

and simply holding

hood shell into position and marking the appropriate

location for vent opening.

NOTE: Locations can be made easier by remov-

ing the fan power pack. Simply unplug the power

cord near the front (See Section C, Step 2) and

loosen 4 wing nuts. Assembly

can be removed

through the front.

3. Connect

hood to electrical

supply as outlined

Section C.

Be sure that damper which is supplied

with this

model is properly installed.

4. Attach damper to hood to give required venting.

damper is attached to the back of hood, be sure

damper hinge is toward the top. See Figure 1 and 2.

5. Complete duct connections

so they are air tight.

6. Re-assemble

fan power pack.

C. Connect hood to

electrical supply

Make electrical

connections

in accordance

with the

National

Electrical

Code and applicable

local or-

dinances.

Hood must be permanently

grounded.

1. With a screwdriver

and a pair of pliers, remove

knockout from underside

of unit. See Figure 4.

2. Disconnect

attachment

plug between switch box &

rear wiring box. See Figure 5. Press two ears on

male plug to disconnect.

3. Pull power supply cord through hole-in the bottom

of oven hood until slack is removed.

4. Set hood on top of range.

5. Lift front edge enough to connect hood power supply

cord to receptacle

in top of range. Figure 4.

6. Loosen screws holding two mounting plates on back

of hood, see Fig. 3. Rotate plates until extra holes

in plates line up with holes in range back. Remove

screws in range back and secure hood through

plates using these same two screws.

7. Tighten screws holding plates to hood and range.

VENT HOOD

BOTTOM

SUPPLY CORD

RECEPTACLE

FIGURE 4

PRESS HERE

FIGURE 5

FRl%DoF