Whirlpool RH6330XL SERIES Kurulum Talimatları Kılavuzu - Sayfa 3
Havalandırma Davlumbazı Whirlpool RH6330XL SERIES için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool RH6330XL SERIES 6 sayfaları. Rh6330xl series convertible oven vent hood
Sayfayı Yazdır
ELECTRICAL
VENT CUTOUTS
CUTOUT
A
DUCTLESS
r
VENT COVER
FIGURE 3
B. Locating vent
cutouts
1. Open flip front of hood and remove aluminum filter.
Note: Remove packing screw on top of hood before
trying to remove filter.
2. Location for vent opening can be found by measur-
ing locations
given in Figure 3 or by removing
appropriate
venting
knockout
and simply holding
hood shell into position and marking the appropriate
location for vent opening.
NOTE: Locations can be made easier by remov-
ing the fan power pack. Simply unplug the power
cord near the front (See Section C, Step 2) and
loosen 4 wing nuts. Assembly
can be removed
through the front.
3. Connect
hood to electrical
supply as outlined
in
Section C.
Be sure that damper which is supplied
with this
model is properly installed.
4. Attach damper to hood to give required venting.
If
damper is attached to the back of hood, be sure
damper hinge is toward the top. See Figure 1 and 2.
5. Complete duct connections
so they are air tight.
6. Re-assemble
fan power pack.
C. Connect hood to
electrical supply
Make electrical
connections
in accordance
with the
National
Electrical
Code and applicable
local or-
dinances.
Hood must be permanently
grounded.
1. With a screwdriver
and a pair of pliers, remove
knockout from underside
of unit. See Figure 4.
2. Disconnect
attachment
plug between switch box &
rear wiring box. See Figure 5. Press two ears on
male plug to disconnect.
3. Pull power supply cord through hole-in the bottom
of oven hood until slack is removed.
4. Set hood on top of range.
5. Lift front edge enough to connect hood power supply
cord to receptacle
in top of range. Figure 4.
6. Loosen screws holding two mounting plates on back
of hood, see Fig. 3. Rotate plates until extra holes
in plates line up with holes in range back. Remove
screws in range back and secure hood through
plates using these same two screws.
7. Tighten screws holding plates to hood and range.
VENT HOOD
BOTTOM
SUPPLY CORD
RECEPTACLE
FIGURE 4
1
L
PRESS HERE
FIGURE 5
FRl%DoF
3