- ページ 8

換気フード Whirlpool UXI6536BSSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXI6536BSS 32 ページ。 36" (91.4 cm) island-mount canopy range hood
Whirlpool UXI6536BSS にも：取付説明書および取扱説明書 (32 ページ)

ページを印刷する

Assemble Range Hood

1. Install transition on top of hood (if removed for shipping)

with 2 - 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw (2)

2. Position the 4 vertical supports (A) with the notches

at the bottom and attach to the range hood using

16 - 4.2 x 8 mm screws.

3. Attach the horizontal support (B) using 8 -

4.2 x 8 mm screws.

A. Vertical supports

B. Horizontal support

C. Notched end

4. Attach a second set of vertical supports (A) and set

the vertical height (B). See "Installation Dimensions"

in the "Location Requirements" section to help

determine the desired dimension for vertical height "B."

Secure with 16 - 4.2 x 8 mm T20

A. Vertical supports

B. Vertical height

screws.

Install Range Hood

Non-Vented (recirculating) Installation

1. Attach the air deflector to the upper horizontal support

using 2 mounting screws.

A. Deflector

B. Mounting screws

2. Measure the length of 6" (15.2 cm) duct needed

to connect the transition to the deflector.

NOTE: Vent should fit up inside the deflector

1" (2.5 cm) minimum.

3. Install vent between the transition and the deflector.

NOTE: To make vent installation easier, temporarily remove

the deflector from the chimney support bracket and replace

after vent section is in place.

4. Seal all connections with vent clamps. Continue

with "Range Hood Installation" in this section.

Range Hood Installation

1. Using 2 or more people, lift the range hood assembly

and attach it by snapping the vertical supports to the

spring clips in the upper horizontal support bracket

that is mounted to the ceiling.

NOTE: The range hood assembly must be held in place

while you are installing the screws in the next step.

2. Install 16 - 4.2 x 8 mm screws and tighten to secure.

A. Mounting screws

Connect Vent System

1. Install vent system.

2. Push duct over the exhaust outlet. Seal all connections

with vent clamps.

3. Use caulk to seal all openings.