- ページ 9

換気フード Whirlpool UXT4236ADのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4236AD 34 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood
Whirlpool UXT4236AD にも：取扱説明書 (28 ページ), 取扱説明書 (28 ページ)

ページを印刷する

4. Use saber or keyhole saw to cut the circular vent opening.

Circular vent opening

*5"

(12.7 cm)

*From wall, not

cabinet frame

Style 3 - Cut Openings for 7" (17.8 cm) Round Vent

To make a circular vent openings on the underside of the

cabinet top and bottom:

1. Mark a centerline on the underside of the top of cabinet.

2. Mark a line 5" (12.7 cm) from the back wall on the underside

of the top and bottom of cabinet.

3. Use a compass or a circle template to draw a circle with a

diameter that is ¼" (0.64 cm) larger than the vent.

4. Use saber or keyhole saw to cut the circular vent opening.

*5"

(12.7 cm)

*From wall, not

cabinet frame

Install Vent System

1. Install vent through the vent opening in upper cabinet or wall.

Complete venting system according to the selected venting

method. See "Venting Requirements" section.

2. Use caulking to seal exterior wall or roof opening around the

cap.

Cabinet

cutouts

7 ¹/₄" (18.4 cm) diam.

cabinet cutouts

Install Range Hood

NOTE: Your model will have a 3¼" x 10" (8.3 x 25.4 cm)

rectangular vent damper on the inside of the range hood.

1. Remove the 3¼" x 10" (8.3 x 25.4 cm) rectangular vent

damper attached with 3.5 x 9.5 mm screws on the inside your

range hood. Use these screws to install the rectangular vent

damper.

¹⁄₄

A. 3

" x 10" (8.3 x 25.4 cm) rectangular vent damper

B. 3.5 x 9.5 mm screws

2. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

A. Keyhole slot

3. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.

A. Drill pilot hole.

4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot

holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads

and cabinet to slide range hood into place.

¹⁄₄"

(6.4 mm)