- ページ 9
楽器アンプ AER 9000-0043-8911のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AER 9000-0043-8911 16 ページ。
ページを印刷する
General Note:
Use of 48V or 24V phantom power
(Phantom power = remote supply, here: powering
an audio device via the connected audio line)
Turn on the phantom power only if the unit con-
nected to the XLR sockets of channels 2 and 3/4 is
designed to handle it!
In general, suitable units are e.g. condenser
microphones, active DI-boxes and other special
audio devices, whose power supply is drawn from
the phantom power. Such devices are also labelled
accordingly; please heed the permissible power
consumption (max.10mA).
High-quality dynamic microphones with a balanced
signal need no phantom power, but can handle it
anyway.
Other devices, which have not been designed
explicitly for phantom power operation, can suffer
from considerable malfunctions and damage may
result as well.
Examples of devices that may be damaged by
incorrect application of phantom power include:
Low-cost dynamic microphones with a mono jack-
plug (unbalanced signal) that were fitted afterwards
with an XLR connector.
Audio devices with a balanced XLR output (e.g.
DI-boxes, effects devices, instrument preamps with
a DI output etc.) which are not protected against
phantom power applied to their XLR output. (The
DI connectors on AER products are protected
against applied phantom power.)
Other audio devices (such as preamps, effects
pedals etc.) whose unbalanced line output was
replaced by an XLR socket.
If in doubt please consult the manufacturer of the
device you are using.
5.4 Phantom power
Microphones requiring 48V phantom power can be
directly connected to the XLR sockets of channels 2
and 3/4. The phantom power can be switched on and
off via the 48V-switch.
The jack sockets of channel 1 and 3/4 can additi-
onally be supplied 15V-Phantomspeisung by an
internal jumper.
Please note: For these alterations the device must
be opened, therefore only qualified service person-
nel may carry out the modifications concerning the
activation of phantom power.
5.5 Stereo-Simulation
The Domino
is mono – thus L-out and R-out are
2.A
carrying the same output-signal. You can use these
sockets to connect additional active AER fullrange-
systems (e.g. AG 8
, CX 8, AS Q8, AS 281), whose levels
2
are adjusted by the pre master-control independent
of the overall volume (master) of your Domino
activating the stereo-simulation (stereo sim.-switch
pressed), a stereo-like, wider sound impression is
generated.
On stage (Domino 3 as monitor) the sound remains
unchanged..
P.S. For questions or suggestions contact us:
. By
2.A
9