- ページ 5

エアクリーナー AeraMax AM IVのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。AeraMax AM IV 6 ページ。 Pro air quality control system

MAIN ASSEMBLY INSTALLATION

WARNING:

To avoid the risk of electrocution confirm the electrical supply has been disconnected or switched off before continuing any installation work.

Fig 12

The power connector (B, in Fig

12) will carry power from the rear

housing to the main housing once

the assemblies are fully seated. The

main assembly will attach to the rear

housing assembly by the four screws

previously removed (Fig 5 & 6). Two

snap hooks (A, in Fig 12) will hold the

main and rear assemblies together

until the screws can be installed.

RE-INSTALLING FILTERS

IMPORTANT:

Make sure all plastic wrap is removed from filters.

Fig 16

Make sure filters are in correct order

- pre-filter / carbon filter / HEPA

filter - and inserted into filter frame

(Fig 16).

Fig 20

Once the unit is closed re-establish

power. Lights on the control panel will

be visible through the lens, indicating

the unit is operational (Fig 20). The

power light indicator will flash once

a second.

Fig 13

Carefully align the main assembly

with the rear housing assembly.

Slowly press into place until snap is

heard, and there is no gap between

the assemblies (Fig 13). The unit

should now support its own weight.

Fig 17

IMPORTANT: Make sure filter

detection area aligns with window

in filter frame (Fig 17).

Fig 14

Fig 15

Install six screws (previously removed) to secure main assembly to rear

housing assembly (Fig 14 & 15).

Fig 18

Open front panel by pressing

latches on both sides of unit. Allow

door to open fully. Insert filters

– IMPORTANT: make sure filter

detection window is aligned in

upper right corner (Fig 18).

LOCKING ACCESS PANEL

Fig 21

Fig 19

Close front panel by pressing

firmly until both sides latch closed

(Fig 19).

To restrict access to the control panel

and filters the unit can be locked. To

lock, insert the key provided and

rotate clockwise ¼ turn (Fig 21).