- ページ 2

浄水器 CALEFFI 5495 SEP4のPDF 設置、試運転、および保守に関する説明書をオンラインで閲覧またはダウンロードできます。CALEFFI 5495 SEP4 4 ページ。 4-in-1 hydraulic, air, dirt and magnetic separator, ansi flanged
CALEFFI 5495 SEP4 にも：マニュアル (16 ページ), 設置、試運転、および保守に関する説明書 (4 ページ)

ページを印刷する

CAUTION: If the SEP4™ is not installed, commissioned and maintained

properly, according to the instructions contained in this manual, it may not

operate correctly and may endanger the user.

CAUTION: Make sure that all the connecting pipework is water tight.

CAUTION: When making the water connections, make sure that the hydronic

separator connecting pipework is not mechanically over-stressed. Over time

this could cause breakages, with consequent water losses which, in turn,

could cause harm to property and/or people.

CAUTION: Water temperatures higher than 100°F (38°C) can be dangerous.

During the installation, commissioning and maintenance of the hydronic

separator, take the necessary precautions to ensure that such temperatures

do not endanger people.

Technical specifications

Materials

Separator body:

Air vent body & shut-off and drain valve body:

Internal element:

Air vent seal:

Air vent float:

Magnet:

Magnet probe:

Performance

Suitable fluids:

Max. operating pressure:

Temperature range: - with insulation

Particle separation capacity:

Air separation efficiency:

Ferrous impurities separation efficiency:

Connections

Flanged:

Drain valve:

- connections 2"– 6":

- connection 8"– 14":

Thermo well tap (8 — 14" only):

- front center:

- inlet/outlet flanges:

Agency Approval

Series NA549_M is designed and built in accordance with Section VIII, Division

1 of the ASME Boiler and Pressure Vessel Code and tagged and registered with

the National Board of Boiler and Pressure Vessel Inspector, and CRN

registered, and stamped for 150 psi (10 bar) working pressure, with ASME U

stamp. 12"-14" is CRN pending, contact Caleffi.

water and non-hazardous glycol solutions up to 50%

- without insulation

100% removal to microbubble level

2"–14" ANSI B16.5 150 CLASS RF

epoxy resin coated steel body

300 series stainless steel

stainless steel

neodymium rare-earth

150 psi (10 bar)

32–220°F (0 – 105°C)

32–270°F (0 – 132°C)

up to 100% removal

1¼" NPT female

2" NPT female

¾" NPT female

½" NPT female

brass

VITON

brass

to 5 μm