ページを印刷する
- 1. Table of Contents
- 2. Introduction
- 3. Getting Started
- 4. Turning On/Off
- 5. Setting Time
- 6. Changing Units of Measurement
- 7. Activating the Sensor
- 8. Automatic Sensor Clean (ASC)
- 9. How to Establish if an ASC Is Needed
- 10. Quick Sensor Clean
- 11. Performing a Blow Test
- 12. Understanding the Results
- 13. Maintaining Your Alcosense
- 14. Accessories
- 15. Servicing
- 16. Legal
5) Remove the cap from the ventilation hole and replace it in the bottom
right hand corner where it originally came from.
6) If the result you got was "LO" please perform an ASC (see page 10) then
perform steps 1-6 again.
If the result is anything other than "LO" (e.g. an alcohol reading)
perform an ASC, when completed your unit is ready to use.
9