- ページ 21

プリンター Xerox DocuColor 5750のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Xerox DocuColor 5750 40 ページ。 Digital color printer / copier
Xerox DocuColor 5750 にも：リファレンス・マニュアル (8 ページ), リファレンス・マニュアル (7 ページ), リファレンス・マニュアル (7 ページ), リファレンス・マニュアル (9 ページ), 補足マニュアル (8 ページ), スタートマニュアル (46 ページ), 補足マニュアル (10 ページ), マニュアル (9 ページ)

Status

Code

Tray Paper

The control logic has sensed that the the paper size is not being detected correctly.

Size

Initial action:

Sensing for

Go to the Paper Tray which was selected on the Control Panel and verify that the Paper Size Indicator is set

Tray 1, Tray

to the correct paper size that is loaded in the Paper Tray.

2, Tray 3,

Tray 4, or

Go to the Paper Tray which was selected on the Control Panel and verify that the paper is loaded correctly.

the Bypass

NOTE : Check for obvious damage, missing or broken Drive Motor gear assemblies and drive belts. These

Tray

items may cause a sensor failure to be displayed as an operator error message.

If the problem still exists:

Place a service call.

08-105,

The control logic sensed a timing problem from the Feed Out sensor for Tray 1 (08-105), Tray 2 (08-110), Tray 3 (08-

110, 115,

115) or Tray 4 (08-120).

120

Initial action:

For the appropriate tray, check the Tray Feed Out Sensor actuator for freedom of movement and proper

installation.

Check for proper installation of the appropriate Paper Guide.

For the appropriate tray, check the Feed Sensor, Nudger, Retard and Feed Rolls shaft, for cleanliness,

damage and excessive wear.

Clean the Feed, Retard and Nudger Rolls with a damp cloth (water) (REP 5.22) (REP 5.24).

Fan the paper or replace the paper with a new ream of paper.

If the problem still exists:

Place a service call.

5750 DocuCare Service Manual

Description/Direction

5/98

2-21

Fault Code Procedures