- ページ 18

プリンターアクセサリー Xerox DocuPrint C3055 DXのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Xerox DocuPrint C3055 DX 33 ページ。 Internal hard disk
Xerox DocuPrint C3055 DX にも：インストレーション・マニュアル (8 ページ), インストレーション・マニュアル (16 ページ), 設定マニュアル (20 ページ), インストレーション・マニュアル (16 ページ)

ページを印刷する

[Off]

Does not skip blank pages.

Note

• Pages that only contain white images or spaces entered with external characters will be printed as blank

pages even when this is set to [On].

• When [On] is selected, and if [2 Sided Print] or [2 Pages Up] is enabled, blank pages will be skipped

during printing.

Image Enhance

Image Enhance is a feature that artificially enhances resolution by smoothing out transitions

between black and white and reducing jagged appearance. Set whether or not to enable

Image Enhance by selecting [On] (default) or [Off].

Character Range

Sets whether or not to extend the position of the right margin.

The following options are available:

[Normal] (default)

Sets the right margin at column 136 at 10 cpi.

[Extended]

Depending on the zoom ratio setting, this extends the position of the right margin when

there is enough space to the right of column 136 at 10 cpi and prints also in that extended

area.

Note

• When [Character Range] is changed from [Extended] to [Normal], the left and right margins will be reset

to the defaults.

• When the right margin is set by a command, the position specified by the command will be the right

edge.

Character Mode

Character Mode is a feature that sends printer control commands in characters instead of

in hexadecimal numbers. When sending printer control commands from an IBM host

computer through a computer that supports Character Mode, set the start character string

to "&$%$" or "$?!#".

The following options are available:

[Off] (default)

Disables Character Mode.

["&$%$" Entry]

Uses "&$%$" as the start character string.

["$?!#" Entry]

Uses "$?!#" as the start character string.

ESC/P Switch

Note

• The values for [Text], [Minimum Text], [Char. Code Table], [Page Length], and [1 inch Skip] are not

affected by extension commands sent from users.

Text

Sets the print quality mode to [High Quality] (default) or [Draft].

Note

• This only changes the status of the setting and not the actual print quality.

• This setting is affected by "Text" commands sent from users.

Minimum Text

Sets whether or not to reduce the size of single-byte characters when printing.

The following options are available:

2 Setting the ESC/P Mode