Xerox DocuPrint C3055 DX Посібник з налаштування - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник з налаштування для Аксесуари для принтерів Xerox DocuPrint C3055 DX. Xerox DocuPrint C3055 DX 33 сторінки. Internal hard disk
Також для Xerox DocuPrint C3055 DX: Посібник з монтажу (8 сторінок), Посібник з монтажу (16 сторінок), Посібник з налаштування (20 сторінок), Посібник з монтажу (16 сторінок)
Друкувати сторінку
[Off]
Does not skip blank pages.
Note
• Pages that only contain white images or spaces entered with external characters will be printed as blank
pages even when this is set to [On].
• When [On] is selected, and if [2 Sided Print] or [2 Pages Up] is enabled, blank pages will be skipped
during printing.
Image Enhance
Image Enhance is a feature that artificially enhances resolution by smoothing out transitions
between black and white and reducing jagged appearance. Set whether or not to enable
Image Enhance by selecting [On] (default) or [Off].
Character Range
Sets whether or not to extend the position of the right margin.
The following options are available:
[Normal] (default)
Sets the right margin at column 136 at 10 cpi.
[Extended]
Depending on the zoom ratio setting, this extends the position of the right margin when
there is enough space to the right of column 136 at 10 cpi and prints also in that extended
area.
Note
• When [Character Range] is changed from [Extended] to [Normal], the left and right margins will be reset
to the defaults.
• When the right margin is set by a command, the position specified by the command will be the right
edge.
Character Mode
Character Mode is a feature that sends printer control commands in characters instead of
in hexadecimal numbers. When sending printer control commands from an IBM host
computer through a computer that supports Character Mode, set the start character string
to "&$%$" or "$?!#".
The following options are available:
[Off] (default)
Disables Character Mode.
["&$%$" Entry]
Uses "&$%$" as the start character string.
["$?!#" Entry]
Uses "$?!#" as the start character string.
ESC/P Switch
Note
• The values for [Text], [Minimum Text], [Char. Code Table], [Page Length], and [1 inch Skip] are not
affected by extension commands sent from users.
Text
Sets the print quality mode to [High Quality] (default) or [Draft].
Note
• This only changes the status of the setting and not the actual print quality.
• This setting is affected by "Text" commands sent from users.
Minimum Text
Sets whether or not to reduce the size of single-byte characters when printing.
The following options are available:
18
2 Setting the ESC/P Mode