- ページ 5

セキュリティシステム Alderon Industries VersAlarm 4XのPDF 操作、メンテナンス、設置マニュアルをオンラインで閲覧またはダウンロードできます。Alderon Industries VersAlarm 4X 6 ページ。 2-zone outdoor
Alderon Industries VersAlarm 4X にも：操作、メンテナンス、設置マニュアル (3 ページ)

ページを印刷する

VersAlarm

2-Zone | Outdoor Alarm System, Type 4X

Operation, Maintenance and Installation Manual

Testing

Make sure all steps of the installation process are completed and there is

power to the product. When powered, the green LEDs should illuminate.

Test monthly to ensure system integrity.

1. To test alarm function, press and hold (1-second +) the test/silence

button (Fig. 7), the red alarm LEDs should illuminate (flashing) with the

green power/zone indicator LEDs illuminated (solid), buzzer should

annunciate in a pulse tone, and auxiliary contacts should activate.

2. The sensors (signaling device) should be connected to the alarm

terminals labeled ALM1 and ALM2 on the alarm circuit board. Activate

each sensor separately, the red alarm LEDs should illuminate (flashing)

and the green zone indicator LED should illuminate (solid) for zone-1

(left) and zone-2 (right), buzzer should annunciate in a pulse tone, and

the auxiliary contacts should activate.

3. To test alarm silence function, activate the sensor for zone-1 to simulate

an alarm condition, then press/hold (1-second +) the test/silence button

and the buzzer should silence while the alarm LEDs remain illuminated,

flashing and the left green zone indicator LED should remain

illuminated (solid). Then, deactivate the sensor, the alarm condition

should clear and the alarm should auto reset for the next alarm cycle.

Repeat this process for the zone-2 sensor.

4. Models with a pump terminal block, the pump should be off once power

is applied and the pump switch is deactivated. Activate the pump switch

and the pump should turn on. Repeat to ensure switch works properly.

Alarm Systems

Control Panels

Alderon Industries - Hawley, MN | 218.483.3034 | [email protected] | alderonind.com

™

Float Switches

Leak Detection Systems

(Fig. 7)

Notes: Place finger in the center of the test/silence capacitive

touch button to activate, button sensor will ignore edge touches.

To disable the green power LEDs, press and hold the test/silence

button for approximately 8-seconds. The green LEDs will pulse

three times and the green power LED indicators will turn off.

Repeat this process to turn them back on.

P/N: QSG00307_Rev01

Page 5 of 6