- ページ 3

セキュリティシステム Alderon Industries Vizzyalarm VZW-02のPDF 操作、メンテナンス、設置マニュアルをオンラインで閲覧またはダウンロードできます。Alderon Industries Vizzyalarm VZW-02 6 ページ。

Vizzyalarm™ 1-Zone WiFi Alarm Panel - Installation Instructions

Installation of the Alarm Panel

3. If connecting to an existing alarm security system or building automation system (BAS), use 18 gauge 2-conductor wire to

connect the existing product to the AUX inputs on the terminal block (Fig. 7). See below for wiring information. The

auxiliary contacts are activated when the sensor (signaling device) contacts are "closed" during an alarm condition

(normally open or normally closed). When connected, run the wire(s) towards the bottom/center of the alarm panel to go

through the wiring access hole once the enclosure cover is replaced (Fig. 9 and Fig. 10).

4. Connect the sensor (signaling device) to the ALARM inputs on the terminal block (Fig. 8). See below for wiring

information. The alarm is activated when any "dry" type sensor that "closes" during an alarm condition (normally open or

normally closed). When connected, run the wire(s) towards the bottom/center of the alarm panel to go through the wiring

access hole once the enclosure cover is replaced (Fig. 9 and Fig. 10).

Note: When installing a sensor or device, always refer to its installation instructions for complete operating information.

CAUTION: Route all wires away from sharp objects and internal components when installing wires.

Auxiliary Contacts:

Terminals AUX

Connects to external monitoring device

Normally Open; Single Pole, Single Throw

30VDC, 700mA maximum

Note: The auxiliary dry contacts of the alarm panel are normally open ONLY,

recommended to use 18 gauge 2-conductor wire. Used for remote monitoring.

Sensor/Signaling Device:

Terminals ALARM

Zone-1 Alarm

Normally Open or Normally Closed

3-10VAC/DC, 10mA minimum

Note: Use normally open sensors (signaling device) for high level alarm indication

and normally closed sensors (signaling device) for low level alarm indication.

5. After the wiring is completed and before replacing the enclosure cover, run the wire(s) towards the bottom/center of the

alarm panel to go through the wiring access hole once the enclosure cover is replaced (Fig. 9 and Fig. 10).

CAUTION: Route all wires away from sharp objects and internal components when installing wires.

Alderon Industries, LLC - Leading Edge Control Products | 218.483.3034 | [email protected] | [email protected] | alderonind.com

(continued)

(Fig. 9)

(Fig. 7; auxiliary contacts)

(BAS)

(Fig. 8; sensor/signaling device)

(Fig. 10)

Installation Instructions | Page 3

(ALARM)