- ページ 2

セキュリティシステム Direct Supply AttendantのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Direct Supply Attendant 2 ページ。 Pen light
Direct Supply Attendant にも：オーナーズマニュアル (2 ページ), オーナーズマニュアル (12 ページ), オーナーズマニュアル (8 ページ), オーナーズマニュアル (2 ページ), オーナーズマニュアル (2 ページ), オーナーズマニュアル (12 ページ), オーナーズマニュアル (2 ページ)

ページを印刷する

Introduction and

Definitions & Symbols

introduction

Direct Supply Attendant PIR alarms are battery-powered

monitors that alarm when a resident attempts to leave their

bed. Attendant PIR alarms are intended to be used on beds to

assist caregivers trained in its use.

Direct Supply Attendant Alarms are intended to help augment

caregivers' comprehensive resident mobility management

programs. They are not a substitute for the visual monitoring

and care of residents by trained caregivers.

Definitions and Symbols

note: Indicates a tip.

Caution: Indicates correct operating or maintenance procedures

in order to prevent damage to or destruction of the equipment

or other property.

Warning: Calls attention to a potential danger that requires correct

procedures or practices in order to prevent personal injury.

Device: Your Direct Supply Attendant PIR Alarm.

You And Your: The facility, community or other entity that has

purchased the device.

We, Us, And Our: Direct Supply Manufacturing, Inc.

• Attention. read the instructions.

Trouble Shooting

If your system does not function when tested, follow these steps:

Step 1: Verify that you are using a fully charged battery.

Step 2: Verify that the alarm switch is in the "Chime"position.

• WArning – If these troubleshooting tips do not resolve the

problem, immediately take the Alarm out of service, substitute

another working Alarm and contact Direct Supply Equipment

& Furnishings.

Product Description

Pir Alarm

• T hree position switch - select between "Off" and

"Chime" positions

• P ower source – runs on one 9V battery (not included)

• 3 0 foot x 60° coverage area

Testing, Cleaning & Storage

Testing

Test the device and check the battery level before every use.

• WArning – Always verify the system is working properly

before leaving a resident unattended.

Cleaning

To clean the device, use disinfectant wipes. Do not immerse

in any liquid or solution.

Storage

Store device indoors in a dry, cool location.

Do not store near heaters or other devices that could

physically damage the product.

Top of Bracket

Directions for Use

instructions & Setup.

Step 1

: Insert a 9V battery (not included) into the

battery compartment.

Top of Bracket

Back of Sensor

Battery Compartment

Top of Bracket

Back of Sensor

Battery Compartment

Step 2

: Mount PIR Alarm in the desired monitoring

area, such as a resident's bedside, chair side

or doorway.

Top of Bracket

Step 3

: Turn the PIR Alarm on by moving the switch into

Back of Sensor

the "Chime"position.

Battery Compartment

Step 4

: Test the PIR Alarm by moving through the desired

area, and verifying that the PIR alarm sounds.

Adjust the angle of the PIR Alarm as necessary

to provide sufficient coverage of the desired

monitoring area.

Step 5

: Reset the PIR Alarm by moving the switch

into the "Off" position, and then back into the

"Chime"position.

Step 6

: Always test the device before each use.

Back of Sensor

Battery Compartment