- ページ 9

医療機器 Direct Supply Panacea 1000のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Direct Supply Panacea 1000 20 ページ。 Adjustable-height low bed

NOTE: Unpack the bed in an area with sufficient room to work. Do not allow residents near the

bed until it has been completely set up and the work area has been cleared of all debris.

1. Inspect the bed for shipping damage. If the bed is damaged, DO NOT USE BED and

immediately contact Direct Supply Equipment & Furnishings

2. Verify the proper bed model and size was shipped. If you feel there was a mistake,

DO NOT USE BED and immediately contact Direct Supply Equipment & Furnishings.

Installation Of Head and Foot Panels

Tools required: Phillips head screwdriver

Head Panel Installation:

1. Head panel has label on back.

2. Lay panel on soft surface front face down.

3. Head panel brackets are longer of two sizes (Figure 1).

4. Install head panel brackets with four screws provided.

5. Bracket offset should face up (Figure 2). Do not tighten until

after fitting mounting brackets into bed sockets.

6. Go to final assembly below.

Foot Panel Installation:

1. Foot panel does not have label on back.

2. Lay panel on soft surface front face down.

3. Foot panel brackets are shorter of two sizes (Figure 1).

4. Install the foot panel brackets with four screws provided.

Bracket offset should face up (Figure 2) Do not tighten until

after fitting mounting brackets into bed sockets.

5. Go to final assembly below.

Final Assembly Step for Head Panel and Frame-mounted

Foot Panel:

1. Insert head and foot panel as shown with mounting

hardware facing head of the bed (Figure 3).

2. Tighten all screws with panels in place.

3. Panels should slip in and out of their sockets easily

and securely.

Directions for Use

for further instruction.

Head Panel

Bracket-10.5"

Figure 1

Offset facing up

Figure 2

Figure 3

1-800-634-7328

directsupply.com

■

Foot Panel

Bracket-6.9"