Direct Supply Panacea 1000 Owner's Manual - Page 9
Browse online or download pdf Owner's Manual for Medical Equipment Direct Supply Panacea 1000. Direct Supply Panacea 1000 20 pages. Adjustable-height low bed
Print PageUnpacking
NOTE: Unpack the bed in an area with sufficient room to work. Do not allow residents near the
bed until it has been completely set up and the work area has been cleared of all debris.
1. Inspect the bed for shipping damage. If the bed is damaged, DO NOT USE BED and
immediately contact Direct Supply Equipment & Furnishings
2. Verify the proper bed model and size was shipped. If you feel there was a mistake,
DO NOT USE BED and immediately contact Direct Supply Equipment & Furnishings.
Assembly
Installation Of Head and Foot Panels
Tools required: Phillips head screwdriver
Head Panel Installation:
1. Head panel has label on back.
2. Lay panel on soft surface front face down.
3. Head panel brackets are longer of two sizes (Figure 1).
4. Install head panel brackets with four screws provided.
5. Bracket offset should face up (Figure 2). Do not tighten until
after fitting mounting brackets into bed sockets.
6. Go to final assembly below.
Foot Panel Installation:
1. Foot panel does not have label on back.
2. Lay panel on soft surface front face down.
3. Foot panel brackets are shorter of two sizes (Figure 1).
4. Install the foot panel brackets with four screws provided.
Bracket offset should face up (Figure 2) Do not tighten until
after fitting mounting brackets into bed sockets.
5. Go to final assembly below.
Final Assembly Step for Head Panel and Frame-mounted
Foot Panel:
1. Insert head and foot panel as shown with mounting
hardware facing head of the bed (Figure 3).
2. Tighten all screws with panels in place.
3. Panels should slip in and out of their sockets easily
and securely.
Directions for Use
for further instruction.
®
Head Panel
Bracket-10.5"
Figure 1
Offset facing up
Figure 2
Figure 3
1-800-634-7328
directsupply.com
■
Foot Panel
Bracket-6.9"
9