- ページ 6

コントローラー eControls RT2のPDF 住宅所有者とインストーラー・マニュアルをオンラインで閲覧またはダウンロードできます。eControls RT2 12 ページ。 Wireless whf control
eControls RT2 にも: ユーザー&インストーラーズマニュアル (8 ページ)

Homes with plaster walls with steel lathe may experience wireless communication interference
when using wireless controls.
For more information on installing and using the RT2, visit the "eControls WHF Channel", RT2 Installation
Video and RT2 Homeowner Video.
!
CAUTIONS
Turn off power before installing whole house fan or
WHF controls.
Read and follow all instructions carefully, including
those included with the whole house fan.
Read entire manual before installing products.
Follow all local electrical codes during installation. All
wiring must conform to local and national electrical
codes.
Installation should be performed by a qualified
individual with sufficient experience and skill.
Use cautions when mounting components to surfaces
that may have concealed wiring beneath the surface.
When servicing WHF Controls or accessing products,
turn off all power to these items.

WIRELESS COMMUNICATION

The RT2 wireless control and the RM2 radio module included in this
kit have been programmed with a unique ID number and ONLY
communicate with each other.
This enables multiple WHF installations in the same home or in
neighboring homes without interference.
The ID Number on the RT2 should always match the ID Number on
the RM2 - see below.

INSTALLATION

Model RM2
WHF Radio Module
OA3MRF89XAM9A
Contains Transmitter Module FCC ID:
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
RM2
ID #
V. X.XX
01-02
1467 / 19-01

ATTENTION INSTALLER

1)
Wire FC3J control board to WHF. Install control board
in single gang electrical box located on WHF.
2)
Connect the FC3J control board to the RM2 radio
module using the Plug&Play cable provided.
If you are using a power cord to power the WHF,
the control board can be wired to the WHF, the
RM2 radio module connected to the control board
and options set before sending out for installation.
3)
Install optional Outdoor Temperature Sensor and
wire to the RM2.
Install batteries in the RT2 and set options.
4)
5) Power WHF only after setting options. Test installation.
Same
ID Number
6
Model RT2
Pat. Pend.
Wireless WHF Control
Made in USA
eControls
eControls
Laguna Hills, CA / eControlsUSA.com
Contains Transmitter Module FCC ID:
OA3MRF89XAM9A
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
RT2
ID #
Ver X.XX
01-02
1234 / 19-01