- ページ 4

楽器 Yamaha YPP-50のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha YPP-50 20 ページ。 Yamaha personal electronic piano owner's manual

KEYBOARD STAND ASSEMBLY

NOTE: Although the YPP-50 keyboard stand can be assembled

by a single person, the job is much easier with two people.

Open the box and remove all the parts.

On opening the box you should find the parts shown in the

illustration. Check to make sure that all the required parts, are

provided.

Invert the main unit (A).

When main unit (A) is removed from the box, place it upside-

down on a soft, non-abrasive surface such as a clean rug or

blanket to prevent scratches to the finish. This inverted posi-

tion makes it easier to attach the assembled keyboard stand

later on.

Attach the side panels (D) to the front (B) and

rear (C) panels.

Begin by installing the joint connectors in the front (B) and rear

(the rear panel is the wider one) are attached between the side

panels (D) using two long bolts at each end. The sides of the

side panels (D) with the recesses at the top face inwards; the

direction in which the feet extend from the side panels is the

"front" (the direction the keyboard faces). The metal brackets

on the front (B) and rear (C) panels face upwards and inwards.

Attach the first panel loosely so that the second panel slides

into position easily, then attach the second panel and finally

tighten all eight bolts. When the assembly is complete and the

bolts are securely tightened, snap the eight plastic bolt covers

into place over the bolt heads.

When installing the joint connectors in the holes in the panels,

make sure that the arrows printed on their upper surface face

in the direction shown in the illustration.