- ページ 5

アンプ Yamaha THR10II WirelessのPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Yamaha THR10II Wireless 20 ページ。
Yamaha THR10II Wireless にも：クイックマニュアル (2 ページ)

!2 [ECHO /REV] knob

Selects one of four different effects: ECHO (tape echo), ECHO/REV (tape echo/reverb), SPRING (spring

reverb), and HALL (hall reverb).

Turn the knob to the right to increase the amount of each effect.

* Turn the knob fully to the left to set the effect OFF.

* When ECHO or ECHO/REV is selected, the [TAP/TUNER] button

!3 [GUITAR] knob

Adjusts the overall volume of the guitar sound.

* This knob's setting has no effect on the signal sent to the [USB] jack

* The volume output to the [LINE OUT] [L] [R] jack (THR30II Wireless only) is constant regardless of the setting of the [GUI-

TAR] knob.

!4 [AUDIO] knob

Adjusts the audio playback volume for audio from the computer connected to the [USB] jack @0 , an audio

device connected to the [AUX] jack !7, or a smart device connected by Bluetooth

!5 [INPUT] jack

This is a standard phone jack used to connect a guitar to the THR-II.

* Connecting the Relay G10T to the [INPUT] jack starts charging that device automatically. (THR-II Wireless only)

* The optimal channel is set automatically by connecting the Relay G10T to the [INPUT] jack for at least 10 seconds. (THR-II

Wireless only)

!6 [PHONES] jack

This is a stereo mini phone jack used to connect stereo headphones to the THR-II.

* Speaker sound is muted when a plug is inserted into the [PHONES] jack.

!7 [AUX] jack

This is a stereo mini phone jack used to connect an external audio device to the THR-II.

* The signal received at the [AUX] jack is not sent to the [USB] jack

!8 [USER MEMORY] [1] [2] [3] [4] [5] button

Saves up to five sets of amp section controller settings (GAIN, MASTER, BASS, MIDDLE, TREBLE, EFFECT,

ECHO/REV).

Press and hold the number of the desired [USER MEMORY] button for saving your settings to (about 2 seconds).

The save operation is complete when the memory number for the button being pushed appears in the LED Display

w. Press one of the numbered buttons (less than 2 seconds) to recall the saved settings.

* On the THR10II Wireless and THR10II, enable Bluetooth by pressing the [USER MEMORY] button [4] and [5] simultane-

ously.(Same as [Bluetooth] button

!9 [Bluetooth]button (THR30II Wireless only)

Set the Bluetooth. Hold the Bluetooth button (for more than three seconds) to switch the pairing mode (the

LED Display w flashes in green).

For further details of Bluetooth connecting, refer to the Connecting to a smart device.

)

THR30II Wireless THR10II Wireless THR10II

can be used to set the delay time.

(page

Names and Functions

10).

(page

10)

Reference Manual