- ページ 3

ページを印刷する

Directed Xpresskit DBALL2 インストレーション・マニュアル

Platform: DBALL2

Firmware: REN11

Wiring Diagram

UCH (under driver dash)

Brake Switch : Gray or Pink, pin 6

Bypass Activation

(see next page)

Not required in D2D mode.

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

All adapters are displayed from the wire side (unless specified otherwise).

HS CAN High: Tan/Black: 3

HS CAN Low: Tan: 4

NO Relay1: Brown: 7

COM Relay1: Yellow: 8

(+) 12v

(+) Brake Bypass: Yellow/Red: 11

(+)Brake Bypass: Brown/Red: 12

(+) 12V

(+) 12V: Red: 13

(-) Ground: Black: 14

(-) Ground

(-) Handbrake Status Output: Black/White: 1

(-) Door Status Output: Green/White: 3

(-) Rap Off: Red/Black: 4

(AC) Tach Output: Violet/White: 5

[1]

(+) Ignition

Output: Gray: 6

(+) Ignition Status Input

(AC) Tach Input

[1]

(-) Door Status Input

(-)Handbrake Status Input

E Black 24-pin conn.

at BCM

Driver door switch : Blue/White, pin 9

HS CAN Low: Black/White or White, pin 27

HS CAN High: Green/White or Green, pin 26

DBALL

Programming button

DBALL2

LED

(-) Lock Output

(-) Unlock Output

(-) Aux1 Output

(+) Parking Light Output

(+) Start Output

(+) Ignition Output

(-) GWR Status Output

(-) Ground

(+) 12V

C Grey 40-pin

connector at UCH

10: Blue/White: (-) GWR (Status) Input

9: Pink: (+) Ignition Input

8: Violet: (+) Start Input

7: Pink/White: (+) Parking Lights Input

4: White/Violet: (-) AUX 1

2: Blue: (-) Unlock Input

1: Green: (-) Lock Input

(+)12V

(-) Ground

P#: XKD2D65

Rev.: 20230129

Page 3