- ページ 11

電動工具 Clarke 6480231のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke 6480231 17 ページ。 Electric drill bit sharpener

• Make sure that the flat

sided spindle lines up with

the groove in the wheel

base.

8. Replace the head assembly

and screws.

NOTE: Replacement grinding

stones can be

purchased via the

CLARKE International

Parts & Service department (see bottom of page).

CLEANING

1. Keep the surface of your sharpener free of grit, dirt, and grease. Use a

damp soapy cloth or non-toxic solvents and regular wipe down the

grinding stone assembly.

2. DO NOT use petroleum based solvents.

3. Keep the air vents free of foreign matter at all times by using an air duster.

4. If the motor does not operate, it may need to be serviced or replaced by a

qualified technician.

TROUBLESHOOTING

Error/Fault

Tool does not work

Insufficient Sharpening

Performance

If the motor turns on, but the grinding wheel does not spin, make sure the

adjustment cylinder's inner flat sided spindle lines up with the outer flats of the

spindle as described in Changing the Grinding Stone on page 10/11.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Cause

No power supply

Grinding stone too worn Replace the grinding

Remedy

Check the cable, plug

and the fuse and

replace where

necessary.

stone (see page 10)