Clarke 6480231 원본 사용 설명서 - 페이지 11

{카테고리_이름} Clarke 6480231에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6480231 17 페이지. Electric drill bit sharpener

• Make sure that the flat

sided spindle lines up with

the groove in the wheel

base.

8. Replace the head assembly

and screws.

NOTE: Replacement grinding

stones can be

purchased via the

CLARKE International

Parts & Service department (see bottom of page).

CLEANING

1. Keep the surface of your sharpener free of grit, dirt, and grease. Use a

damp soapy cloth or non-toxic solvents and regular wipe down the

grinding stone assembly.

2. DO NOT use petroleum based solvents.

3. Keep the air vents free of foreign matter at all times by using an air duster.

4. If the motor does not operate, it may need to be serviced or replaced by a

qualified technician.

TROUBLESHOOTING

Error/Fault

Tool does not work

Insufficient Sharpening

Performance

If the motor turns on, but the grinding wheel does not spin, make sure the

adjustment cylinder's inner flat sided spindle lines up with the outer flats of the

spindle as described in Changing the Grinding Stone on page 10/11.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Cause

No power supply

Grinding stone too worn Replace the grinding

Remedy

Check the cable, plug

and the fuse and

replace where

necessary.

stone (see page 10)