- ページ 13

電動工具 Clarke Metalworker CL251MHのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke Metalworker CL251MH 16 ページ。 Metalworker milling/drilling attachment

4. Mill Chuck Set

Part Number: 7601853

A set of 6 collets with chuck with sizes:

•

3mm

•

4mm

•

5mm

•

6mm

•

8mm

•

10mm

Insert the shank of the chuck into the Mill Head Spindle and screw on to the end of the draw bolt,

shown a 'A' Fig 7 on page 12. Tighten the draw bolt, holding the spindle steady by hand or by

using a tommy bar (not provided) in the hole provided in the spindle.

Unscrew and remove the end collar 'A', insert the appropriate collet and reattach the end collar.

Insert the respective end mill into the collet and tighten using the 'C' spanner.

To remove the chuck, undo the draw bolt a turn or two, then tap its' head using a mallet to break the seal.

5. Drill Chuck with Key

Part Number:

CL251MH910

Insert the shank of the chuck into the spindle and

screw on to the end of the draw bolt, shown at 'A'

Fig 7 on page 12.

Tighten the draw bolt, holding the spindle steady

by hand or by using a tommy bar (not provided),

in the hole provided in the spindle.

To remove the chuck, undo the draw bolt a turn or

two, then tap its' head using a mallet to break the

seal.

SPARE PARTS & SERVICING

For Spare Parts or Servicing, please contact your nearest dealer, or

CLARKE International, on one of the following numbers.

PARTS - 020 8558 6696 : SERVICE - 020 8556 4443

PARTS & SERVICE FAX - 020 8 558 3622

NOTE: This tool is supplied with the machine.