Clarke Metalworker CL251MH 운영 및 유지 관리 지침 - 페이지 13
{카테고리_이름} Clarke Metalworker CL251MH에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Metalworker CL251MH 16 페이지. Metalworker milling/drilling attachment
페이지 인쇄
4. Mill Chuck Set
Part Number: 7601853
A set of 6 collets with chuck with sizes:
•
3mm
•
4mm
•
5mm
•
6mm
•
8mm
•
10mm
1.
Insert the shank of the chuck into the Mill Head Spindle and screw on to the end of the draw bolt,
shown a 'A' Fig 7 on page 12. Tighten the draw bolt, holding the spindle steady by hand or by
using a tommy bar (not provided) in the hole provided in the spindle.
2.
Unscrew and remove the end collar 'A', insert the appropriate collet and reattach the end collar.
3.
Insert the respective end mill into the collet and tighten using the 'C' spanner.
To remove the chuck, undo the draw bolt a turn or two, then tap its' head using a mallet to break the seal.
5. Drill Chuck with Key
Part Number:
CL251MH910
Insert the shank of the chuck into the spindle and
screw on to the end of the draw bolt, shown at 'A'
Fig 7 on page 12.
Tighten the draw bolt, holding the spindle steady
by hand or by using a tommy bar (not provided),
in the hole provided in the spindle.
To remove the chuck, undo the draw bolt a turn or
two, then tap its' head using a mallet to break the
seal.
SPARE PARTS & SERVICING
For Spare Parts or Servicing, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS - 020 8558 6696 : SERVICE - 020 8556 4443
PARTS E-MAIL - [email protected]
SERVICE E-MAIL - [email protected]
PARTS & SERVICE FAX - 020 8 558 3622
NOTE: This tool is supplied with the machine.
13
A