- ページ 16

オーブン Zanussi ZOF35501のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZOF35501 24 ページ。 Oven
Zanussi ZOF35501 にも：ユーザーマニュアル (24 ページ), ユーザーマニュアル (24 ページ)

ページを印刷する

1. Installation

4. Set the oven temperature to 250°C and

let the oven operate for 1 hour.

5. Clean the oven cavity with a soft and

damp sponge.

Caution! Do not attempt to clean

catalytic surfaces with oven sprays,

abrasive cleaners, soap or other cleaning

agents. This may damage the catalytic surface.

Discolouration of the catalytic surface has

no effect on catalytic properties.

Shelf Support Rails

You can remove the shelf support rails to

clean the side walls.

Removing the shelf support rails

Pull the front of

the shelf support rail

away from the side

wall.

Installing the shelf support rails

Install the shelf support rails in opposite se-

quence.

The rounded ends of the shelf support

rails must point to the front.

Oven door and glass panels

To clean the oven door remove it.

Caution! Be careful when you remove

the door from the appliance. The door is

heavy!

Removing the oven door

1. Open the oven door as far as it goes.

2. Lift up clamping levers (A) on the two

door hinges fully.

Pull the rear shelf

support rail away

from the side wall

and remove it.

3. Close the oven door until the first position

(angle approx. 45°).

45°

4. Hold of the oven door with one hand on

each side and pull it away from the oven

at an upwards angle.

Put the oven door with the outer side

down on a soft and level surface to pre-

vent scratches.

5. Now you can remove the inner glass pan-

els and clean them.

To install the door follow the procedure in

reverse.

The oven door has 2, 3 or 4 panels of

glass (depends on the model)

Removing and cleaning the door glasses

1. Hold the door trim (B) on the top edge of

the door at the two sides and push in-

wards to release the clip seal.

2. Pull the door trim to the front to remove it.