Zanussi ZOF35501 Kullanıcı Kılavuzu - Sayfa 16
Fırın Zanussi ZOF35501 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Zanussi ZOF35501 24 sayfaları. Oven
Ayrıca Zanussi ZOF35501 için: Kullanıcı Kılavuzu (24 sayfalar), Kullanıcı Kılavuzu (24 sayfalar)
Sayfayı Yazdır
4. Set the oven temperature to 250°C and
let the oven operate for 1 hour.
5. Clean the oven cavity with a soft and
damp sponge.
Caution! Do not attempt to clean
catalytic surfaces with oven sprays,
abrasive cleaners, soap or other cleaning
agents. This may damage the catalytic surface.
Discolouration of the catalytic surface has
no effect on catalytic properties.
Shelf Support Rails
You can remove the shelf support rails to
clean the side walls.
Removing the shelf support rails
1
Pull the front of
the shelf support rail
away from the side
wall.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove
the door from the appliance. The door is
heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
16
2
1
2
Pull the rear shelf
support rail away
from the side wall
and remove it.
A
3. Close the oven door until the first position
(angle approx. 45°).
45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to pre-
vent scratches.
5. Now you can remove the inner glass pan-
els and clean them.
To install the door follow the procedure in
reverse.
The oven door has 2, 3 or 4 panels of
glass (depends on the model)
Removing and cleaning the door glasses
1. Hold the door trim (B) on the top edge of
the door at the two sides and push in-
wards to release the clip seal.
B
2. Pull the door trim to the front to remove it.
A
www.zanussi.com