- ページ 19
オーブン Zanussi ZOP37907のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZOP37907 28 ページ。
ページを印刷するCare and cleaning
WARNING!
Refer to Safety chapters.
Notes on cleaning
• Clean the front of the appliance with a soft
cloth with warm water and a cleaning agent.
• To clean metal surfaces, use a usual
cleaning agent.
• Clean the appliance interior after each use.
Fat accumulation or other food remains may
result in a fire. The risk is higher for the grill
pan.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all accessories after each use and let
them dry. Use a soft cloth with warm water
and a cleaning agent.
• If you have nonstick accessories, do not
clean them using aggressive agents, sharp-
edged objects or a dishwasher. It can cause
damage to the nonstick coating.
Stainless steel or aluminium appliances
Clean the oven door with a wet
sponge only. Dry it with a soft cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean the
oven control panel with the same
precautions.
Removing the shelf supports
To clean the oven, remove the shelf supports.
1
Pull the front of the
1
shelf support away
from the side wall.
Install the shelf supports in the opposite
sequence.
www.zanussi.com
2
1
2
Pull the rear end of
2
the shelf support
away from the side
wall and remove it.
Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if you did
not fully close the oven door. In
some models, the display shows
"C3" when this error occurs.
WARNING!
The appliance becomes very hot.
There is a risk of burns.
CAUTION!
If there are other appliances installed
in the same cabinet, do not use
them at the same time as the
Pyrolysis function. It can cause
damage to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot
water, so that the residues do not burn from
the hot air.
3. Set the Pyrolysis function. Refer to "Oven
functions".
4. When
flashes, press
the necessary procedure:
Option
P1
P2
After 2 seconds the procedure starts.
You can use the End function to delay the start
of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set temperature, the
door locks. The display shows the symbol
or
to set
Description
If the oven is not
very dirty. Time
of the proce-
dure: 1 h.
If you cannot
easily remove
the dirt. Time of
the procedure: 1
h 30 min.
19