- ページ 11
洗濯機 Zanussi FJE 1207のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi FJE 1207 23 ページ。 Zanussi washer user manual
Zanussi FJE 1207 にも： ユーザーマニュアル (24 ページ)
ページを印刷する
At the end of the cycle, the light of the START/
PAUSE button
will flash and the programme
phase indicator light
will remain lit to indicate that
the water must be drained.
To complete the cycle, choose one of the following
options:
• Draining and spin:
- Press the START/PAUSE button. The machine
will drain the water, then spin the laundry at the
maximum speed provided for the selected
programme.
-
Select spin speed by means of button 5, and
press the START/PAUSE button.
• Drain only
- Press the RESET button
cause the DRAIN light
the START/PAUSE button.
Important! If you accidentally press the RESET
button more than once, the memory will be
cleared. To drain the water, select any washing
programme by means of the FABRIC button
then press RESET three times in order to select
the DRAIN position (only the DRAIN light
remain lit).
6 SOIL DEGREE button
This button allows you to select the suitable washing
for your laundry.
= normally soiled laundry.
The machine automatically proposes this
position when you select the programme/
fabric.
= heavy soiled laundry.
Only for cotton and synthetic fabrics. The
washing phase will be prolonged by approx.
10 minutes.
= Slightly soiled laundry.
The washing time will be reduced according to
the type of fabric and the selected
temperature.
Not for wool/hand wash
.
7 OPTIONS button
Press this button to select the following options:
• PREWASH
: select this option if you wish your
laundry to be prewashed before the main wash
(not available for wool/hand wash and quick
wash).
The prewash ends with a short spin in programmes
for cotton and synthetic fabrics, whereas in the
programme for delicate fabrics the water is only
once, so as to
to light up, then press
,
will
and quick wash
11
drained.
• BIO: this function can be selected for cotton and
synthetics with a washing temperature of 40° or
more degrees.
The machine will maintain a temperature of 40° for
about 10 minutes to enable the enzymes contained
in the detergent to eliminate the dirt.
To be used for laundry with "stubborn" stains.
8 START/PAUSE button
This button has three functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
• Draining of water and spinning after the
execution of programmes with the RINSE HOLD
option
.
9 RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory; the programme phase
indicator lights must be off, otherwise, the next time
you switch the washing machine on, the audible
warning signals relevant to the end of the previous
cycle will be given.
You can also press the RESET button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go out).