- ページ 18
洗濯機 Zanussi FL 1090のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi FL 1090 26 ページ。 Front-loading washing machine
Operating sequence
Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer in order to activate the ECO
valve. Then run a cotton cycle at 60°C, with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out a soak or a prewash
programme, pour detergent into the appropriate
compartment marked
3. Measure out the additive
If required, pour fabric softener into the compartment
marked
, and bleach into the compartment
marked
without exceeding the «MAX» mark.
Close the drawer gently. This is particularly important
if you are using a fabric conditioner because if the
drawer is slammed it will cause the conditioner to
enter the machine prematurely.
.
.
4. Switch the machine on
To switch the machine on, press the ON/OFF button
: the mains-on light comes on.
The display will show three blinking dashes or a
blinking zero.
5. Select the desired programme / fabric
Press the FABRIC (TEJIDOS) button repeatedly, in
order to select the desired programme/fabric. The
relevant light will light up.
The lights relevant to the phases that form the
programme will light up.
The display will show the duration of the selected
programme, calculated on the basis of the maximum
load for each type of fabric. The START/PAUSE
(INICIO/PAUSA) button light will start flashing.
If the load of laundry to be washed is small, at the
beginning of the cycle the display will still indicate the
duration relevant to the maximum load. The duration
value will be gradually adjusted during the execution
of the cycle.
42