ページを印刷する
Fitting the vapour protection
Screw the vapour protecting strip onto the front
part of the worktop using four 3.5 x 16 screws.
Fitting the sealing strips to the sides
of the appliance
To ensure closer contact with adjacent kitchen
units, fit the plastic sealings strips down both sides
of the front of the machine before inserting it into
the recess.
Fixing to the adjacent units
To prevent the dishwasher tilting, it must be
secured to either the worktop or adjacent kitchen
cabinet/wall using the brackets supplied. Insert the
two fixing brackets into the slots provided in the top
front part of the dishwasher as shown in the figure.
Secure the brackets to adjacent units with the 3.5 x 16
screws using the upper or the side holes.
The appliance must be secured to the
underside of the worktop using the brackets
provided.
Failure to do this could cause damage or
injury.
Adjusting the door balance
When the dishwasher door is correctly balanced it
will remain in position when left ajar. The door
balance may need to be adjusted when the decor
panel is fitted. Turn the screws until the correct
balance is reached:
- heavy panel - turn clockwise
- light panel - turn anticlockwise
After the adjustment of the door balance, cover the
screw holes with the two plugs supplied with the
machine.
II25
A
A
II23
II54
II47
24
6 0 0 m m
A
A
II68
PFI10GB