- ページ 8

ホブ Zanussi ZEV6240FBAのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZEV6240FBA 16 ページ。 Hob
Zanussi ZEV6240FBA にも：ユーザーマニュアル (12 ページ)

ページを印刷する

Problem

The appliance deactivates.

The residual heat indicator does

not come on.

The sensor fields become hot.

comes on.

and a number come on.

If you tried the above solutions and cannot re-

pair the problem, speak to your dealer or the

customer service. Give the data from the rating

plate, three digit letter code for the glass ce-

ramic (it is in the corner of the glass surface)

and an error message that comes on.

Installation instructions

Warning! Refer to the Safety chapters.

Before the installation

Before the installation of the appliance, record

the information below from the rating plate. The

rating plate is on the bottom of the appliance

casing.

• Model ...........................

• PNC .............................

• Serial number ....................

Built-in appliances

• Only use the built-in appliances after you as-

semble the appliance into correct built-in

units and work surfaces that align to the

standards.

Possible cause

You touched 2 or more sensor

fields at the same time.

There is water or fat stains on the

control panel.

You put something on the sensor

field

The cooking zone is not hot be-

cause it operated only for a short

time.

The cookware is too large or you

put it too near to the controls.

The Automatic Switch Off oper-

ates.

There is an error in the appliance.

Make sure, you operated the appliance correct-

ly. If not the servicing by a customer service

technician or dealer will not be free of charge,

also during the warranty period. The instruc-

tions about the customer service and condi-

tions of guarantee are in the guarantee booklet.

Connection cable

• Use the correct mains cable of type H05BB-

• Replace the damaged mains cable with a

To attach the seal.

• Clean the worktop in the area of the cut out

• Bond the seal stripe supplied on the lower

Touch only one sensor field.

Clean the control panel.

Remove the object from the sen-

sor field.

If the cooking zone operated suffi-

ciently long to be hot, speak to the

service centre.

Put large cookware on the rear

cooking zones if necessary.

Deactivate the appliance and acti-

vate it again.

Disconnect the appliance from the

electrical supply for some time.

Disconnect the fuse from the elec-

trical system of the house. Con-

nect it again. If

again, speak to the service centre.

F Tmax 90°C (or higher) for a single phase or

two phase connection.

special cable (type H05BB-F Tmax 90°C or

higher). Speak to your local Service Centre.

section.

edge of the appliance along the outer edge

of the glass ceramic. Do not extend it. Let

stay the cut ends in the middle of one side.

When, you cut it to length (add some mm),

push the two ends together.

Remedy

comes on