ページを印刷するFitting the Hob into the Worktop
Before fitting the hob into the cut out,
an adhesive seal must be fitted to the
underside outside edge of the hob.
It is essential that no gaps are left in
this seal in order to prevent spillage near
the hob seeping into the cabinet below.
1) Remove the pan supports, the burners
caps and crowns and turn the hob
upside down, taking care the ignition
candles are not damaged in this
operation.
2) Place the sealing gasket all around the
glass top edge as shown in Fig. 4.
3) Place the hob in the cut out, taking
care of its centring.
4) Fix the hob with the relevant fixing
clamps and screws(see Fig. 5). When
the screws have been tightened, the
excess seal can be removed.
FO 2320
FO 2321
Fig. 4
sealing gasket
Fig. 5
19