- ページ 11

ホブ Zanussi ZGG65414XAのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZGG65414XA 16 ページ。 Hob
Zanussi ZGG65414XA にも：ユーザーマニュアル (16 ページ), ユーザーマニュアル (32 ページ)

ページを印刷する

rates. Make sure that you install the plug in a

correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

To prevent contact between the cable and the

appliance below the hob use the clamps which

are on the side of the cabinet.

A) Rigid copper pipe or flexible pipe of stain-

less steel

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make sure

that the cable section is applicable to the volt-

age and the working temperature. The yellow/

green earth wire must be approximately 2 cm

longer than the brown (or black) phase wire.

Building In

min. 100 mm

min. 55 mm

30 mm

www.zanussi.com

A) supplied seal

B) supplied brackets

for the minimum distance between the applian-

ces.

Possibilities for insertion

Kitchen unit with door

The panel installed below the hob must be easy

to remove and let an easy access in case a

technical assistance intervention is necessary.

min. 650 mm

a) Removable panel

b) Space for connections

560 mm

10 mm

3 mm

Caution! Install the appliance only on a

worktop with flat surface.

If you install the hob under a hood, please

see the installation instructions of the hood

30 mm

min 20 mm

60 mm

(max 150 mm)

11 mm