Zanussi ZGG65414XA Руководство пользователя - Страница 11
Просмотреть онлайн или скачать pdf Руководство пользователя для Варочная панель Zanussi ZGG65414XA. Zanussi ZGG65414XA 16 страниц. Hob
Также для Zanussi ZGG65414XA: Руководство пользователя (16 страниц), Руководство пользователя (32 страниц)
Печатать страницу
rates. Make sure that you install the plug in a
correct socket.
• Always use a correctly installed shockproof
socket.
• Make sure that there is an access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• There is a risk of fire when the appliance is in
connection with an extension cable, an
adapter or a multiple connection. Make sure
that the ground connection agrees with the
standards and regulations.
• Do not let the power cable to heat up to a
temperature higher than 90° C.
To prevent contact between the cable and the
appliance below the hob use the clamps which
are on the side of the cabinet.
A
A) Rigid copper pipe or flexible pipe of stain-
less steel
Replacement of the connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make sure
that the cable section is applicable to the volt-
age and the working temperature. The yellow/
green earth wire must be approximately 2 cm
longer than the brown (or black) phase wire.
Building In
min. 100 mm
min. 55 mm
30 mm
www.zanussi.com
A) supplied seal
A) supplied seal
B) supplied brackets
for the minimum distance between the applian-
ces.
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be easy
to remove and let an easy access in case a
technical assistance intervention is necessary.
min. 650 mm
a) Removable panel
b) Space for connections
560 mm
10 mm
3 mm
Caution! Install the appliance only on a
worktop with flat surface.
If you install the hob under a hood, please
see the installation instructions of the hood
30 mm
A
min 20 mm
60 mm
(max 150 mm)
B
A
11 mm
11 mm
A
B
11