- ページ 10
冷凍庫 Zanussi ZBF22456SVのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZBF22456SV 17 ページ。
ページを印刷する
Problem
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
INSTALLATION
LOCATION
Refer to the assembly instructions for
the installation.
To ensure best performance, install the appliance
well away from sources of heat such as radiators,
boilers, direct sunlight etc. Make sure that air can
circulate freely around the back of the cabinet.
POSITIONING
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance.
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
10
Possible cause
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The door has been opened
often.
The "QuickFreeze function"
is switched on.
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
ELECTRICAL CONNECTION
The wires in the mains lead are coloured in
accordance with the following code:
Solution
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Open the door only if necessary.
Refer to "QuickFreeze function".
Make sure that there is cold air
circulation in the appliance.
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range. If you have any
doubts regarding where to install the
appliance, please turn to the vendor,
to our customer service or to the
nearest Authorised Service Centre.
CAUTION! Any electrical work
required to install this appliance
should be carried out by a qualified
electrician or competent person.
WARNING! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.