ページを印刷する
Door reversibility
Unplug the freezer before performing the following
operations:
Remove the ventilation grill (D-Fig. 3).
Remove the lower hinge (E-Fig. 3) by loosening the
two fastening screws.
F
F
F
F
D071
Remove the door by sliding it out of the upper pin
(A-Fig. 4).
Unscrew the pin and the washer (A+B-Fig. 4) and
refit them on the opposite side.
D427
Refit the door.
Refit the lower hinge (E-Fig. 3) on the opposite side
by means of the two screws that have been
previously removed.
Remove the plastic plug (F-Fig. 3) from the
ventilation grill (D) pushing it as shown by the
arrow.
Fit the plastic plug (G) supplied with the appliance,
in the seat left free on the opposite side.
Refit the ventilation grill.
Fig. 3
G
E
E
G
G
D
D
Fig. 4
C
B
A
Remove the handle and refit it on the opposite side
(Fig. 5).
D162
The holes that are not used are to be masked with
the plastic plugs removed.
If, after having reversed the door, it is not in line
with the unit, the top hinge can be adjusted.
To do this, use a 10 mm spanner as shown in Figure
4; slacken the nut, align the door by pushing it to the
left or right, then re-tighten the nut.
Attention
After completion of the door reversibility operation,
verify that the door gasket is adherent to the
cabinet. If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of
the gasket or accelerate this process by heating up
the part involved with a normal hairdrier.
Fig. 5
35