Zanussi ZVC 200 S 지침 책자 - 페이지 5

{카테고리_이름} Zanussi ZVC 200 S에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZVC 200 S 8 페이지.

Door reversibility

Unplug the freezer before performing the following

operations:

Remove the ventilation grill (D-Fig. 3).

Remove the lower hinge (E-Fig. 3) by loosening the

two fastening screws.

D071

Remove the door by sliding it out of the upper pin

(A-Fig. 4).

Unscrew the pin and the washer (A+B-Fig. 4) and

reﬁt them on the opposite side.

D427

Reﬁt the door.

Reﬁt the lower hinge (E-Fig. 3) on the opposite side

by means of the two screws that have been

previously removed.

Remove the plastic plug (F-Fig. 3) from the

ventilation grill (D) pushing it as shown by the

arrow.

Fit the plastic plug (G) supplied with the appliance,

in the seat left free on the opposite side.

Reﬁt the ventilation grill.

Fig. 3

Fig. 4

Remove the handle and reﬁt it on the opposite side

(Fig. 5).

D162

The holes that are not used are to be masked with

the plastic plugs removed.

If, after having reversed the door, it is not in line

with the unit, the top hinge can be adjusted.

To do this, use a 10 mm spanner as shown in Figure

4; slacken the nut, align the door by pushing it to the

left or right, then re-tighten the nut.

Attention

After completion of the door reversibility operation,

verify that the door gasket is adherent to the

cabinet. If the ambient temperature is cold (i.e. in

Winter), the gasket may not ﬁt perfectly to the

cabinet. In that case, wait for the natural ﬁtting of

the gasket or accelerate this process by heating up

the part involved with a normal hairdrier.

Fig. 5