- ページ 19

換気フード Zanussi ZHC4284のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZHC4284 44 ページ。 Zanussi chimney hood product brochure
Zanussi ZHC4284 にも：特徴 (5 ページ)

Chimney Stack

The chimney consists of two sections.

The lower chimney measures (with the Hood body and

recirculation grilles) 750 mm and the upper chimney

measures 460 mm. The overall installed measurement

is min. 750 - max 1200 mm.

Fitting the Upper Chimney and

the Hood Body

• Insert the upper duct and fix it on the top of the

upper duct connection using the 12c screws (2.9 x

9.5) supplied with the appliance.

Recirculation version

• It is necessary to make sure that the air outlet con-

nection 15 is placed correctly so that the air outlet

grid in it corresponds to that of the chimney.

• If the grids of the two parts are not corresponding

to each other, it will be necessary to remove the

chimney and to adjust the position of the air outlet

connection 15, and at last to assembly the parts again

by following the earlier indications.

Before fixing the hood body to the frame:

• Open the suction panel by turning the specific

knob.

• Disconnect the panel from the hood canopy by sliding

the fixing pin lever.

• Remove the grease filters from the hood body.

• Remove any activated charcoal filters.

• From below, use the 4 screws 12f (M6 x 10) provided

to fix the hood body to the frame.

Electrical Connection

• Connect the Hood to the mains power supply, inserting

a two-pole cut-out switch with contact aperture of at

least 3 mm along the line.

• Pull the Comfort Panel to open it, ensure that the

supply cable connector is properly inserted into the

Suction device socket

• Join the connectors.

• Install the odour filter and the charcoal filter in case

the hood is to be used in recycling version.

• Install the grease filter again, and successively the

suction panel.

INSTALLING THE COOKER HOOD

��