- ページ 18

換気フード Zanussi ZHC4284のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Zanussi ZHC4284 44 ページ。 Zanussi chimney hood product brochure
Zanussi ZHC4284 にも：特徴 (5 ページ)

ページを印刷する

Extraction

The cooker hood is more effective when used in the extraction mode (ducted to the outside).

Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of

Ø125mm (5") or Ø150mm (6").

For the best performance use the shortest possible duct run and the minimum number of bends.

Where flexible ducting is fitted it should not be turned through very tight bends as this may impair the performance of the

hood.

It is recommended a maximum length of 3 metres with one bend, to be installed, to be reduced metre for each 90o bend.

If a distance is greater than 3 metres the efficiency of the hood could be impaired.

The ducting used must be manufactured from fire retardent material conforming to the relevant British Standard or DIN

4102-B1.

When the cooker hood is ducted to the outside the charcoal filter must be removed.

Ducting Connection

Connect the ducting chosen to:

• the Ø150mm ducting spigot on top of the motor housing,

or the Ø150-120mm ducting spigot item 9 and secure

using the jubilee clips item 25.

• A Ø120-125mm collar item 10 is provided to fit over

the Ø120mm ducting spigot when 125mm ducting is

fitted.

If the room where the cooker hood is to be used

contains a fuel burning appliance such as a central

heating boiler, then its flue must be of the room

sealed or balanced flue type.

If other types of flue or appliances are fitted sure that

there is an adequate supply of air to the room.

The cooker ducting (extraction mode) must never

be connected to central heating flues, radiators or

water heaters etc.

Recirculation

The cooker hood is supplied specified for use in the recir-

culation mode, with the charcoal filter fitted.

In the recirculation mode contaminated air is passed

through the charcoal filter to be purified and recirculated

into the kitchen through the grille outlets on either side

of the chimney.

Recirculation Connection

• Insert the reducer flange 9 on the air outlet of the

extractor.

• Attach the adhesive Novastik gasket 13 to the air outlet

connection 15 and fix this to the upper frame using the

2 knobs 24.

• Fix the air outlet connection extension piece 14 to the

air outlet connection 15.

• Place the air outlet connection tube 29 between the

two air outlets.

INSTALLING THE COOKER HOOD

��

�

��

�� 10

�

��