- ページ 10

ロックス Directed XpressKit DBALLのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Directed XpressKit DBALL 19 ページ。 Ford5 remote start ready (rsr) installation
Directed XpressKit DBALL にも：インストレーション・マニュアル (16 ページ), マニュアル (14 ページ), インストレーション・マニュアル (16 ページ)

ページを印刷する

Platform: DBALL/DBALL2

Firmware: FORD5 Remote Start Ready (RSR) Installation

Module Programming

Refer to the LED Diagnostics section on page 12 for more information and for troubleshooting purposes.

Important

Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to

ensure everything is correct prior to moving onto the next step.

Note: Before connecting either the XL202 or SmartStart module to DBALL, it is important to ensure that the proper feature and

function programming is selected using XpressVIP (version 4.5 or higher). Visit www.directechs.com to download the latest

version of the application.

Warning!

To take advantage of advanced features, you must use XpressVIP 4.5 (and higher) or the Directechs Mobile app.

Flashing a module using your computer:

1. Connect the interface module to your computer using the

XKLoader2.

2. Go to www.directechs.com using Internet Explorer, and

select the Config for RSR button.

3. Follow the instructions to select your vehicle, installation

type, and configure your options.

4. Once you have configured the firmware options, click on the

FLASH button.

When the flashing operation is successful, you can proceed with the programming instructions below.

SmartStart Installation

The DBALL module must be disconnected from any power source before SmartStart can

be connected to it. Failing to do so could damage DBALL.

To ensure that the D2D communication between SmartStart and DBALL works properly, the

Gray wire must be connected to a ground source (Rev B SmartStart), and the Brown or Blue

loop must be cut (Rev A SmartStart).

Do NOT connect the 2-pin harness (on SmartStart). Power and ground will be provided by

the DBALL D2D connector.

Connect SmartStart to DBALL using the D2D port.

XL202 Installation

Connect XL202 to DBALL using the D2D port.

Connect the 10-pin, 12-pin and 14-pin harnesses to

DBALL, then wait until the LED turns ON solid red.

Note: To skip the transponder programming and use

convenience features only, press the programming button

5 times. The LED will flash orange then proceed to step 3.

Driver 's door must be opened during programming.

Open the remote. Remove the battery. Re-assemble the remote.

Hold the key up to the right side of the steering column. There will be a slot to insert the key

into or a symbol to hold it up against.

Note: If transponder programming was skipped, the LED turns ON solid orange for 3 seconds then shuts off

when programming is done. Press the PTS button to turn the ignition OFF. You have successfully completed

the module programming sequence with convenience features only.

Press the Push-To-Start (PTS) button to turn the ignition ON.

The LED flashes green.

Flashing a module using your smartphone or tablet

1. Connect the interface module to your XKLoader3.

2. Launch the Directechs Mobile app on your smartphone or

tablet.

3. Select FLASH YOUR MODULE and follow the on screen

instructions.

Go to the next page to complete the module programming.

Rev.: 20160317

SmartStart

XL202

Remove

Battery

ENGINE

PUSH 1X

START

STOP

Flashes Green

Page 10

Solid