Platform: DBALL/DBALL2
Firmware: FORD5 Remote Start Ready (RSR) Installation
LED Diagnostics & Troubleshooting
LED
Description
Progra m m ing the Module
Module has no power.
Off
W aiting to begin the
Solid red
programming sequence.
CAN detected.
Flashes green
Bypass is waiting for Ignition
Solid orange
ON.
Bypass was skip.
Flashes orange
Flashes orange
Ready for Key2GO
slowly
Module was successfully
Solid green
x 3 secs
programmed.
Module was successfully
Solid orange
x 3 secs
programmed without bypass.
Module Progra m m ing - Error Code s
Flashes red
CAN2 not detected.
x 2
Flashes red
Bypass data not detected.
x 3
Flashes red
Bypass processing error
x 4
Ex te rna l Module Synchronisa tion
Flashes red,
OBDII feature not supported.
red, then
orange x 10
Active Ground W hile Running
GROUND OUT ON (GW R)
Flashes green
command received.
IGNITION ON command
Flashes red
and orange
received.
Flashes green
START ON command received.
quickly
D2D a nd W 2W Com m a nds
Flashes orange
Lock command received.
x 1
Flashes orange
Unlock command received.
x 2
Trunk release command
Flashes orange
x 3
received.
RSR Code
3x OEM Lock Remote Start
Flashes
Activation was attempted when
red x7
RFTD feature is disabled.
Troubleshooting
Make sure the D2D harness is connected or that the 12 Volt is present
between the red and black wires. If the 12 Volt is present, the module
may be defective.
Make sure that all the connections are correct. See wiring diagram.
Normal operation.
Normal operation.
Normal operation. Immobilizer bypass programming was skipped.
Normal operation. Follow the Key2GO programming.
Normal operation.
Normal operation. Immobilizer bypass programming was skipped.
Check the Tan - Tan/Black wire connections. W ake up the data bus by
turning the ignition on and try again.
Check the bypass line connection. If more than one wire is used, make
sure they are not inverted. Start vehicle using the key to confirm the
OEM equipment is still operational.
Bypass calculation failed. Reset the module and try again. Might be
caused by a bad reading in the first programming attempt or by an
unknown bypass value. If a second attempt fails, connect the module
to Directechs and call Tech Support with the module ID in hand.
Diagnostic data bus not detected. Some features are not supported by
SmartStart. This can be caused by missing wire connections or
module hardware limitation. Refer to "Installation (wiring diagrams &
vehicle wiring reference charts)" to check the connections.
Otherwise, the Ground W hile Running (status) signal was lost or was
never received by the module.
Otherwise, the ignition signal was not received by the module.
Otherwise, the start signal was not received by the module.
If the bypass module fails to flash, it means the module did not receive
the signal. Verify the connections between the bypass and the remote
starter module.
Activated from W eb automatically when using RSR flash tool or can be
done manually.
Rev.: 20160317
Page 14
© 2016 Directed. All rights reserved.
ページを印刷する